SWISSto12 has passed the Critical Design Review for two active phased-array antennas it is building for French operator UNIVITY. The antennas use 3D printed passive radiating front ends and move next into flight hardware production and testing. The review took under a year and sits within UNIVITY's uniShape programme.
What are the two antennas for?
Under the uniShape programme, supported by France 2030 and the French Space Agency CNES, SWISSto12 is developing two active direct radiating arrays. One is an S-band antenna meant to connect satellites directly to standard 5G phones. The other works in the Ka-band at 26 GHz for broadband and feeder links to ground infrastructure.
Together they let one UNIVITY satellite offer broadband and direct-to-device service. UNIVITY plans a constellation in Very Low Earth Orbit that uses operators' existing 5G spectrum.
Where does 3D printing come in?
The antennas belong to the HummingLink line. SWISSto12 prints the passive radiating front ends, which include radiating elements and miniaturised, low-loss filters. These are combined with in-house beamforming circuit boards and digital controls, so the array steers signals electronically without moving parts. Design and manufacture take place at the company's site in Switzerland.
What happens next?
Completing the review shifts the work from detailed design to hardware production and qualification. Flight hardware will be built first, followed by verification and acceptance testing. In January 2026 SWISSto12 secured €73 million in support from European Space Agency member states through its HummingSat partnership, which also covers phased-array antenna technologies.
What it means
For manufacturers eyeing space or RF work, the case shows AM used for a functional, high-frequency component inside a vertically integrated product, not as a standalone part. The milestone is a design review, so flight qualification and acceptance testing are still ahead and production maturity is unproven. Suppliers should expect customers to judge printed RF parts mainly on electrical performance and verification evidence, which makes early agreement on test criteria more important than print cost.
Frequently asked questions
What did SWISSto12 complete?
It completed the Critical Design Review for two active phased-array antennas for UNIVITY, in less than a year. This clears the way for flight hardware production and testing.
Which parts are 3D printed?
SWISSto12 prints the passive radiating front ends, including radiating elements and miniaturised low-loss filters. Beamforming electronics and digital controls are developed in-house.
What do the two antennas do?
An S-band array connects satellites directly to standard 5G phones, and a 26 GHz Ka-band array handles broadband and feeder links to the ground.