How does the four-head layout work?
Toolchangers park one head and fetch another, while nozzle-swapping systems cut and retract filament before exchanging nozzles. Quadro instead leaves all four heads on the rail, each with its own filament, temperature, motor, belt and pulley. Co Print calls this Independent Quad Extruder, or IQEX.
The next head starts heating roughly 30 seconds before it is needed. At a change, the active head docks and the next one moves in. Co Print reports mechanical switch times of 1.00 s to head 2, 1.40 s to head 3 and 1.57 s to head 4, and says priming can add time. Parked heads cool to about 140°C, retract the filament about 1 mm and have the nozzle tip sealed to prevent drips.
What materials and build size does it offer?
One print can combine up to four materials, among them PLA, PETG, TPU, PVA, ABS and carbon fiber filaments, within a 300 mm cube. The heads can also be split in pairs, so two parts print at once, each in two colours.
How reliable are the waste figures?
The figures come from Co Print's own tests of five four-colour models on Quadro, a toolchanger and a large single-nozzle printer, all with 0.4 mm nozzles and 0.2 mm layers. The company claims up to 70 percent shorter print times and up to 90 percent less waste. In one helmet model Quadro produced 58.69 g of waste versus 114.14 g and 301.4 g for the other two. Results vary by model, material and settings.
Software, calibration and pricing
Calibration is automatic: the nozzles touch a reference pin to align heads to head 1, map the bed against a shared Z reference, and run flow calibration before each print. Firmware, QuadrOS, is based on Klipper, and the open-source Co Slicer is derived from OrcaSlicer. CMYK printing and mixed nozzle sizes are in development or testing as free updates. Reward tiers start at $649 against a planned $899 retail price. The campaign runs until 7 December 2026.