What does CHiC2PRINT set out to do?
The project is funded with about €10 million over six years. It aims to join the geometric freedom of 3D printing with plastics already used in industrial production, which are cheap but are normally shaped by moulding. Injection moulding is inexpensive per part but limited in complex shapes, while 3D printing handles almost any geometry but often needs special materials or demanding process steps.
How would the printing work?
Instead of adding material layer by layer, the team uses targeted light to create structures inside an existing plastic body, a technique called volumetric printing. It is paired with a photochemistry approach that makes commercial plastics sensitive to light. In the long run the researchers expect parts whose shape and properties can be tuned, for example regions of different strength within one component. Rapp says objects in established plastic systems could eventually be made much faster than by injection moulding.
What about recycling?
Most printed parts today cannot be recycled and end up incinerated or in landfill. The project plans to separate finished objects fully into their components at end of life, so that the original plastics are recovered and can be processed again. The reports call this step delamination or debonding.
Who is behind it and how does it relate to other work?
Rapp and Rühe both work at IMTEK, the Institute of Microsystems Engineering, in Freiburg's Faculty of Engineering. Rapp, who co-founded the glass printing spin-off Glassomer, heads the Freiburg Materials Research Center. Rühe works on surface coating and leads the livMatS Cluster of Excellence. The ERC chose 48 of more than 950 Synergy proposals this year. Related work includes EPFL, which printed an opaque resin volumetrically, and the University of Birmingham, which made a recyclable resin from lipoic acid. Freiburg instead targets plastics already in industrial use.