AddiWire

Additive manufacturing news and European prices, with independent expert commentary

Automotive

Bosch and Nikon SLM print a one-piece aluminium V8 engine block

Published 1 sourceSummary written with AIDeutsche Version

The Bosch Additive Solution Center in Nuremberg and Nikon SLM Solutions have printed a complete V8 engine block as a single piece in AlSi10Mg aluminium. The build ran on the NXG XII 600, a large-format multi-laser powder bed fusion system. The partners present it as a step toward moving additive manufacturing from development centres into automotive production.

Key facts
  • One-piece V8 engine block printed in AlSi10Mg aluminium alloy
  • Built on the Nikon SLM NXG XII 600 multi-laser system
  • Partners: Bosch Additive Solution Center (Nuremberg) and Nikon SLM Solutions (Lubeck)
  • Casting needs weeks to months of tooling that printing avoids

Context Multi-laser powder bed fusion melts metal powder layer by layer with several lasers working in parallel, which allows larger parts to be built in one job.

Why print an engine block instead of casting it?

A cylinder block is normally cast, which needs weeks or months of tooling development and validation before the first part exists. Casting also limits which shapes can be made reliably. Printing works straight from a digital file and removes the tooling wait.

What does the geometric freedom offer?

The source names cooling channels inside the part, shapes optimised for load paths and several components merged into one as newly reachable. Weight can be cut by placing material only where it carries load, which matters in motorsport.

What is still needed to reach production?

The article stresses that installing a machine is not enough. Bosch brings automotive experience and Nikon SLM brings additive expertise. The work covers material, process settings, design, software links and continuing application development. The open question is how to carry such projects into production with strict performance demands and sizeable volumes.

What it means

The engine block is a technology demonstrator, and the source gives no cost, build time, test results or series plans. For small and mid-sized manufacturers the practical lesson is the collaboration model: results like this needed joint work on material, process and design, not just a machine. Qualification data and cost per part will decide whether such parts leave the development centre. Realistic timelines for production use remain open.

Earlier on AddiWire

Frequently asked questions

Which machine printed the V8 engine block?

It was built on the Nikon SLM Solutions NXG XII 600, a large-format multi-laser powder bed fusion system, in AlSi10Mg aluminium alloy.

Who was involved?

The Bosch Additive Solution Center in Nuremberg and Nikon SLM Solutions of Lubeck, both in Germany.

Is the engine block going into series production?

The source does not say so. It describes the block as a showcase of what the technology can do and of how AM could scale into automotive production.

Read the original reports
  1. DEVELOP3D, 19 Nov 2026