AMCM has connected the EOSPRINT build-preparation software with PanX, a thermomechanical simulation tool from PanOptimization. Build data flows into the simulation, and optimised process settings flow back into the same job, which cuts manual set-up for metal builds, including large parts on the AMCM M 4K and M 8K. The aim is to catch overheating and distortion before printing starts.
How does the data move between the two tools?
Build set-up travels in an openjz file that holds the geometries, the plate layout and the process parameters. Values the file does not contain, such as the time each layer takes, are pulled through the EOSPRINT API. Engineers no longer need to rebuild the job by hand in the simulation, which lowers the risk of entry errors. Printer-specific data can be added to the model, and turnaround can be counted in hours.
What comes back into the build job?
After the analysis, PanX can return adjusted dwell times, compensated geometry and changed laser power to the same file. The laser power is delivered as a TIFF image stack with a matching Smart Fusion Replay file. The link works across EOS systems from M 290-class machines up to the AMCM M 8K, and PanX can also run stand-alone with other metal AM systems.
Why does it matter for large builds?
On a large M 8K build, the demonstration showed how local heat accumulation can lead to distortion, residual stress, internal defects, partly sintered powder and hard depowdering. PanOptimization co-founder Erik Denlinger argues that density cubes and tensile bars cannot reveal such problems, because they depend on geometry and thermal history. The article also notes similar moves by Dyndrite with Ansys and by Materialise with Magics 2025.
What it means
For manufacturers adopting metal powder bed fusion, simulation embedded in build preparation lowers the barrier to using it, since design and production engineers can run it without a simulation specialist. The potential gain is fewer failed or distorted large builds, which matters most for expensive parts. Still, the report gives no figures on scrap reduction or cost, so the business case must be tested on own parts. Smaller firms should also check licence cost and who validates the models.
Frequently asked questions
What did AMCM integrate?
AMCM connected EOSPRINT build preparation with PanX, a thermomechanical simulation platform from PanOptimization, so build data and optimised settings move between them without manual re-entry.
Which machines can use the integration?
It can be used across EOS systems from M 290-class machines to the AMCM M 8K. PanX can also run stand-alone with other metal AM systems.
What can the simulation change in a build?
It can return adjusted dwell times, compensated geometry and laser power settings to the build file, to address overheating and distortion before printing.