Why did a contract research firm start building printers?
Added was founded by Richard Hague, Chris Tuck and Ricky Wildman to take industrial projects that the Nottingham research group could not accept, either because they were too small or because the client needed confidentiality and a commercial timetable. The firm, formerly called Added Scientific, later focused on material jetting and binder jetting, working on ink formulation as well as custom equipment.
To test materials, the team needed to run printheads from several manufacturers on one platform and swap fluids without rebuilding the rig. It made its own driver electronics and fluid handling. Hague describes the result as internal tools that could not be bought elsewhere. He expects research and equipment work to be roughly balanced in revenue this year, and each side feeds the other.
How does JetForge work?
Hague says existing prototyping machines usually tie a head to materials its maker has qualified, which limits use of a customer's own ink, and some development systems lock users to one head supplier. He also notes that complex lab equipment can take researchers months to learn.
JetForge puts the driver board, recirculation pump, ink supply and printhead into one swappable unit called a Blade. JetForge Go has two Blade positions and JetForge Core has six. A position can also hold a curing unit or a droplet inspection unit, depending on the experiment.
What does it take to make an ink print reliably?
Tuck first checks an ink's viscosity at the temperature the head will run at. Thinning with solvent can help jetting but reduces the functional material per drop, and conductive particles that clump need a reformulated ink. Heating is an option for fluids too thick at room temperature.
A single drop proves little, since stability over thousands of firings per second matters. Added films droplets over long runs, because solvent loss or uneven particles can cause drift or erratic jetting. Waveform, fluid or head can then be adjusted to find a stable operating window. With reactive jetting, the team has made silicones and polyurethanes from fluid precursors.
Where does it apply, and what is shown at Formnext?
Tuck sees the nearest opportunity in bespoke electronics, where a conductor deposited during the build can run in three dimensions through a part, and in sensors printed on fabric. Hague also names graphene and dielectric sensor combinations. Past funded projects include desalination spacers with Evove and oral dosage forms with AstraZeneca, though follow-on use in production was left open. Investors Brent Stucker and David Leigh back the launch. At Formnext, 17 to 20 November 2026, JetForge Core is at Hall 12.0, F139 and JetForge Go at Ricoh, Hall 11.0, E58.